Bosch Bosch 45cm slimline fault codes
SPS freestanding and SPV fully integrated. SM denotes a 60cm machine and SP a 45cm one, with a trailing G for the Great Britain market.
Codes on the Bosch 45cm slimline follow the same Bosch scheme as the rest of the range. Where a code behaves differently on this generation, the code page says so.
Bosch fault codes
Every published Bosch code. Open a code to see which models and years it applies to.
- E15The water protection system has activated — there is water in the base of the machine. Turn the tap off and call service. Do not tilt it, whatever else you read.Stop — call an engineer
- E24The machine cannot drain. Bosch publish a full owner procedure for this one, and two warnings about doing it that their UK page leaves out.Get it checked
- E18Water is not getting in. Bosch publish a full owner procedure including a flow rate you can measure with a jug.Get it checked
- E22The filters are soiled or blocked. Bosch give a one-line remedy — clean them — and it is genuinely the whole job.Get it checked
- E16Water is running into the machine continuously, whether or not it is switched on. Bosch give the same instruction as for a leak: tap off, call service.Stop — call an engineer
- E12The heating element has furred up with limescale. Descaling fixes today; setting the water softener correctly stops it coming back.Get it checked
- E27The mains voltage is too low. Bosch state plainly that this is not a fault on the appliance — you want an electrician, not an appliance engineer.Get it checked